Linksys WAG354G (ADSL router) – Aansluiten via UART
Linksys WAG354G v1/v2 (ADSL router)
De UART aansluiting op JP5:
|
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 |
| | MiniPCI | Slot | _________| |*| |*| leds |*| |*| |*| |*| --JP5-------------------- | [5] [4] [3] [2] [1] | ------------------------- _ _ _ ______________________________________________ _ _ _ Legend: 5 GND 4 NC 3 Rx 2 Tx 1 Vcc |
Foto:
Ps. GND en Vcc werken niet!, gebruik alleen RX & TX en voed router met adapter als normaal!
The settings are: 38400 bauds, 8 bits, no parity, 1 stop bit (38400 8N1)
WAG354G V2
|
1 2 3 4 5 6 7 8 9 10 11 |
JP4_______ | | [1] [2] [3] [4] [5] | | | | | |___ _ ___|-|____|-|__leds___|-|_|-|_|-|_|-|_______________________________| Legend: 1 GND 2 NC 3 Rx 4 Tx 5 Vcc |
|
1 2 3 4 5 6 7 |
0x900e0000,0x903d0000 fs (mtd0) 0x90020000,0x903d0000 kernel (mtd1) (The end address is the same as fs...) 0x90000000,0x90020000 Bootloader (mtd2) 0x903d0000,0x903f0000 Lang partition (mtd4) 0x903f0000,0x90400000 NVRAM (mtd3) _____________________________________ TOTAL = 4096K = 4M |
Bron: openwrt.org