The closer you look, the less you see!
3D Printer Firmware
Website Informatie (ENG) The leading developers of Sprinter are currently Kliment, caru and midopple, though many others contribute with their patches. This is a firmware for RAMPS and other reprap single-processor electronics setups. It supports printing from SD card, active …
Mechanica Firmware – Sprinter (verouderd) (RAMPS Shield) Lees meer »
FIRMWARE RAMPS Website Informatie (ENG) THIS FIRMWARE VERSION IS NOW DEPRECATED. ALL FURTHER DEVELOPMENT IS HAPPENING UNDER THE NEW NAME Sprinter This is a firmware for RAMPS and other reprap single-processor electronics setups. It supports printing from SD card, active …
Mechanica Firmware – Klimentkip (verouderd) (RAMPS Shield) Lees meer »
Website Informatie (ENG) Marlin is a firmware for RepRap 3D printers, the software that resides on the controller board and controls the input/output, voltage states, and movement of the 3D printer. It runs specifically on the Arduino platform. Depending on configuration …