Menu
Tag: reprap

Website Informatie (ENG) The leading developers of Sprinter are currently Kliment, caru and midopple, though many others contribute with their patches. This is a firmware for RAMPS and other reprap single-processor electronics setups. It supports printing from SD card, active …

Mechanica Firmware – Sprinter (verouderd) (RAMPS Shield) Read More »

Getagd met , , , ,

FIRMWARE RAMPS Website Informatie (ENG) THIS FIRMWARE VERSION IS NOW DEPRECATED. ALL FURTHER DEVELOPMENT IS HAPPENING UNDER THE NEW NAME Sprinter This is a firmware for RAMPS and other reprap single-processor electronics setups. It supports printing from SD card, active …

Mechanica Firmware – Klimentkip (verouderd) (RAMPS Shield) Read More »

Getagd met , , , ,

Website Informatie (ENG) Marlin is a firmware for RepRap 3D printers, the software that resides on the controller board and controls the input/output, voltage states, and movement of the 3D printer. It runs specifically on theĀ Arduino platform. Depending on configuration …

Mechanica Firmware – Marlin Read More »

Getagd met , , , ,

Bron/source @ reprap.org Informatie (ENG): Previously the accepted method was to cover the PCB heatbed with kapton tape, degrease it and print. An alternative method that has become popular (as of January 2015) is to use a sheet of 3mm …

3D Printer – Heated bed – Reprap, Mendel Read More »

Getagd met , , , ,