Categorie: Firmware (mechanica)

Firmware (mechanica)

Door Geplaatst op Geplaatst in 3D Printer Firmware, Firmware (mechanica) Getagd met , , , ,

FIRMWARE RAMPS Website Informatie (ENG) THIS FIRMWARE VERSION IS NOW DEPRECATED. ALL FURTHER DEVELOPMENT IS HAPPENING UNDER THE NEW NAME Sprinter This is a firmware for RAMPS and other reprap single-processor electronics setups. It supports printing from SD card, active …

Mechanica Firmware – Klimentkip (verouderd) (RAMPS Shield) Lees meer »

Door Geplaatst op Geplaatst in 3D Printer Firmware, Firmware (mechanica) Getagd met , , , ,

Website Informatie (ENG) Marlin is a firmware for RepRap 3D printers, the software that resides on the controller board and controls the input/output, voltage states, and movement of the 3D printer. It runs specifically on the Arduino platform. Depending on configuration …

Mechanica Firmware – Marlin Lees meer »