Mechanica Hardware – Arduino Home made shield (Horus)

Ciclop 3D scanner voorkant schuin

3D Scanner
Ciclop
HOME MADE MET HORUS

Hieronder is een voorbeeld om zelf een “home made board” te maken als besturing voor de Ciclop 3D scanner.

Ciclop homemade board 01

Ciclop homemade board 02

Ciclop homemade board 03

Ciclop homemade board 04

Print:

Ciclop 3D scanner home made print

Firmware uploaden

Wat heb je nodig?
1) Horus firmware

Aan de slag
1) Pak de bestanden/folder uit in de arduino map.
2) Hernoem de map “horus-fw-0.2” naar “horus-fw
3) Dubbelklik op “horus-fw.ino” om de Arduino IDE te openen en het bestand te laden.
(gaat dit niet dan start Arduino IDE en laad het ino bestand handmatig in.)
4) Selecteer de juiste poort en board en klik op uploaden.
5) De Horus firmware is nu op de Arduino geinstalleerd!


Informatie (ENG):

A super simple, quick and dirty shield for the bq ciclop ( only the essential parts, no fuses etc. ) You can look at https://github.com/bq/zum/blob/master/zum-scan/bqZUM_Scan_Shield_Rev.4.PDF and the JPG for the parts and alignment. The only change i did was the ULN2003 instead of the mosfet’s for the control of the laser. On the right side you have to solder a bridge. Powered from the UNO DC-in jack.
Use only at your own risk, is used the parts that i had at home, still a betaversion/work in progress


Download @ Thingiverse