Menu
Tag: reflow oven

After you flashed the firmware with the “UnifiedEngineering” version, you can place a cold junction temperature sensor for better temperatur management. From github: The existing controller makes the assumption that the cold-junction is at 20 degrees Celsius at all times …

T-962 reflow oven 31 – Cold junction compensation Read More »

Getagd met , , , , , , ,

Firmware replacement The standard T-962 firmware is very simple and there are a few flaws in it (temperature overshoot, no coldjuntion compensation, no pwm controlled fan, etc). There is a opensource firmware build on github: https://github.com/UnifiedEngineering/T-962-improvements Github page T-962 reflow …

T-962 reflow oven 30 – Firmware flash Read More »

Getagd met , , , , , ,

Tape replacement As far as we know every unit comes with tape on the heating shield (to prevent shotages from wiring and stuff), this is default masking tape and smells very bad when the oven is in use (some say …

T-962 reflow oven 20 – Tape and fan replacement Read More »

Getagd met , , , , , , ,

Earth connection Safety first!, before powering on the device, open it up and check the wiring of the earth connection on the outside casing, because of the case powder coating it will make NO contact, unscrew it and grind the …

T-962 reflow oven 10 – Wiring and connections Read More »

Getagd met , , , , , , ,